
8 Expansion cards and BBU
Authorized personnel
Authorized specialist personnel can carry out replacement tasks for integral server components. Ask you local Fujitsu service center for more detailed information.
VCAUTION!
Procedures indicated as "Authorized personnel only“ must be done by Fujitsu service personnel or technicians trained by Fujitsu for doing these tasks. Please note that unauthorized interference with the system will void the warranty and exempt the manufacturer from all liability.
IThe number and location of available PCIe slots depends on the CPUMEMR configuration. Make sure that the planned CPUMEMR configuration enables you to use the PCIe slots needed for the individual use case of the server.
For detailed information on configuration rules and supported expansion card types see "Baseboard D3081, CPUMEMR D3131, PCIR D3082 for PRIMERGY RX900 S1 Technical Manual" or in the configurator using the following link:
http://ts.fujitsu.com/products/standard_servers/rack/primergy_rx900s1.html
(for the EMEA market).
Figure 52 shows the PCIe slot configuration. Expansion cards can be installed in the PCIe slots on the PCI Riser (A) and on the baseboard (D). The PCI Riser is connected to the baseboard via the connectors C and E.
The PCIe slots are assigned as follows:
●B: non-hot plug PCIe slots on the PCI Riser
●F: non-hot plug PCIe slot for the Modular Raid controller only
●G: hot-plug PCIe slots
●H: non-hot plug PCIe slots on the baseboard
RX900 S1 | Maintenance Manual | 105 |