Management and diagnostics modules
13Management and diagnostics modules
Authorized personnel
Authorized specialist personnel can carry out replacement tasks for integral server components. Ask you local Fujitsu service center for more detailed information.
VCAUTION!
Procedures indicated as "Authorized personnel only“ must be done by Fujitsu service personnel or technicians trained by Fujitsu for doing these tasks. Please note that unauthorized interference with the system will void the warranty and exempt the manufacturer from all liability.
VCAUTION!
Follow the safety instructions in the chapter "Safety instructions" on page 31.
This section provides information on:
●"Replacing the local service display" on page 248
The ServerView Local Service Display on the front panel of the server enables you to check the status of the key system components at any time without opening the housing. For information on the functions provided by the ServerView Local Service Display see the associated documentation.
●"Replacing the chassis ID board" on page 252 The chassis ID board provides two functions:
–
–Temperature sensor for monitoring the ambient temperature
The functions are essential to monitor the temperature correctly, enable ServerView to display the correct system picture, and to install the server using ServerStart. BIOS/BMC configuration data is kept on the EEPROM on the power distribution board. The data for the EEPROM and the current temperature values are transmitted to the baseboard via the I2C bus.
RX900 S1 | Maintenance Manual | 247 |
