Kawasaki STX-15F service manual Coupling/Output Shaft Installation

ENGINE BOTTOM END 8-9

Coupling

•Using the rotor holder [A], remove the output shaft [B].

Special Tool - Rotor Holder: 57001-1544

Coupling/Output Shaft Installation

•Apply molybdenum disulfide oil solution to the seating sur- face of the output shaft.

•Using the rotor holder [A], install the output shaft [B].

Special Tool - Rotor Holder: 57001-1544

Torque - Output Shaft: 245 N·m (25.0 kgf·m, 180 ft·lb)

•Apply silicone sealant [A] to the crankcase halves mating surfaces on the magneto cover.

•Be sure to install the dowel pins [B].

•Apply grease to the O-ring [A], and fit the O-ring onto the groove of the magneto cover [B].

•Install the magneto cover.

○Be sure to install the washer [C] and the spring [D] into the hole [E] of the bushing.

Torque - Magneto Cover Bolts: 20 N·m (2.0 kgf·m, 14 ft·lb)

•Apply grease to the O-ring [A] and collar inside.

•Install the collar [B] so that the chamfer side [C] faces inward.