Kawasaki STX-15F service manual Camshaft Installation

ENGINE TOP END 6-15

Camshaft, Camshaft Chain

Camshaft Installation

•Be sure to install the following parts. Pins [A]

•Apply molybdenum disulfide oil solution to all cam parts and journals.

NOTE

○The exhaust camshaft has a 320 EX mark [A] and the inlet camshaft has a 320 IN mark [B]. Be careful not to mix up these shafts.

If the camshaft position sensor rotor is removed, install it as follows.

○Insert the pin [A] into the holes [B] in the camshaft and boss [C].

○Fit the projection [A] of the rotor [B] on the camshaft re- cess [C].

○Apply a non-permanent locking agent to the camshaft po- sition sensor rotor bolt [D], and tighten it.

Torque - Camshaft Position Sensor Rotor Bolt: 12 N·m (1.2 kgf·m, 104 in·lb)

•Remove:Coupling Cover Bolts [A] Clamps [B]

Coupling Cover [C]