Kawasaki STX-15F service manual Pump Installation

PUMP AND IMPELLER 11-7

Pump and Impeller

○Take out the pump bracket mounting bolts [A].

○Cut the sealant at the indicated area [A] in the figure and remove the pump bracket [B].

Pump Installation

•Strip off all the old sealant around the pump intake.

•Liberally coat the outside edge of the pump bracket with silicon sealant [A] to form a seal between the bracket and the hull.

Sealant - Kawasaki Bond (Silicone Sealant): 56019-120

•Install the pump bracket [A] to the hull.

○Apply a non-permanent locking agent to the following bolts and torque them.

Torque - Pump Bracket Mounting Bolts (2) [B]: 19 N·m (1.9 kgf·m, 14 ft·lb)

Pump Bracket Mounting Bolts (4) [C]: 9.8 N·m (1.0 kgf·m, 87 in·lb)

○As for the pump bracket mounting bolts (2) in the hull, the bolt heads should be wrapped in silicone sealant.