Kawasaki STX-15F service manual Coupling Damper Inspection, Output Cover Oil Seal Replacement

8-10 ENGINE BOTTOM END

Coupling

•Install: Pins [A] Gasket [B]

•Position the magnet lead [C] as shown.

•Apply grease to the oil seal lip.

•Install the output cover.

○Run the magneto lead [A] between the magneto cover [B] and the output cover [C] as shown.

Torque - Output Cover Bolts: 7.8 N·m (0.80 kgf·m, 69 in·lb)

•Install the coupling damper to the coupling.

•Holding the timing rotor, screw the coupling onto the out- put shaft and tighten it.

Special Tools - Flywheel & Pulley Holder: 57001-1605 Holder Attachment: 57001-1547 Coupling Holder #2: 57001-1423

Torque - Coupling: 98 N·m (10.0 kgf·m, 72 ft·lb)

•Install:Crankshaft Sensor Cover

Engine (see Engine Removal/Installation chapter)

Coupling Damper Inspection

•Refer to Coupling Damper Inspection in the Periodic Maintenance chapter.

Output Cover Oil Seal Replacement

•Remove:

Output Cover (see Coupling/Output Shaft Removal)

•Using the bearing driver [A], remove the oil seals as a set.

Special Tool - Bearing Driver Set: 57001-1129