Kawasaki STX-15F Handrail Removal, Handrail Installation, Drain Plug Housing Removal

HULL/ENGINE HOOD 13-13

Fittings

Handrail Removal

•Remove the seat (see this chapter).

•Disconnect the bilge hoses from the breather fitting.

•Unscrew the mounting nut [A] and washer inside the hull, and remove the lock assembly [B].

•Holding the nuts and washers inside hull, unscrew the mounting bolts [C], and remove the handrail [D].

Handrail Installation

•When installing the lock assembly and handrail, align the projection [A] and stud bolt [B] on the lock assembly with holes [C] on the hull.

Drain Plug Housing Removal

•Unscrewing [B]. the screws [A] and remove the drain plug hous-

Drain Plug Housing Installation

•Check the seal [A] for damage. If necessary, replace new ones.

○Install the new gasket [B] so that its “OUT” mark [C] faces outwards.

Exhaust Outlet Removal

•Unscrew the mounting bolts [A] and remove the holder [B] and exhaust outlet [C].

Exhaust Outlet Installation

•Apply a non-permanent locking agent to the mounting bolts and tighten them securely.