STEERING 12-17

Reverse System

Shift Cable Adjustment

Check the shift cable adjustment.

When the shift lever is in the “F” position, the lower edge [A] of the bucket should be held above the top [B] of the steering nozzle with slight play so it doesn’t interfere with the water flow from the jet pump.

When the shift lever is in the “R” position, the lower stop- per [C] on the bucket should rest against the bottom [D] of the pump cover.

If either position is incorrect, adjust the shift cable.

Put the shift lever in the “R” position.

Loosen the locknut [A] at the end of the shift cable.

Slide back the outer sleeve and take the ball joint [B] off the ball.

Turn the ball joint on the cable to adjust the shift cable.

Connectagain. the ball joint and check the cable adjustment

Whennut. adjustment is correct, tighten the shift cable lock-

Shift Cable Removal

Take out the storage case screws [A] and remove the stor- age case [B].

Loosen[B]. the locknut [A] at the front end of the shift cable

Page 303
Image 303
Kawasaki STX-15F service manual Reverse System, Shift Cable Adjustment, Shift Cable Removal