Kawasaki STX-15F service manual Rubber Parts Location

13-16 HULL/ENGINE HOOD

Rubber Parts

NOTE

○The rubber parts on the watercraft are fastened in place with various adhesives. To replace a rubber part, use a cement in the following table, or an equivalent.

WARNING

Read all warnings and cautions on any solvents and adhesives used. Many of these products are flammable, may be harmful to the skin and eyes, and may give off harmful vapors. Use these sol- vents and adhesives only in a well-ventilated area and never near an open flame.

For this Application	Type
Mats	Synthetic Rubber
Engine Hood Gasket	Adhesive
Front Storage Compartment Cover	(P/N: 92104-3701)
Trim Seal
Detents	Cyanoacrylate Cement
Handlebar Grips

CAUTION

Be very careful that the part is positioned correctly when you apply the cement. It may be impossible to reposition the part.

WARNING

Do not get any cyanoacrylate cement in your eyes or on your skin. If you do get some in your eyes, do not try to wash it out. Contact a physician im- mediately! If you do get some on your fingers, do not touch any other part of your body; your fingers will stick to anything they touch. Allow the cement to cure and it will eventually wear off.

Rubber Parts Location

Engine Hood Gasket [A]

Rear Storage Trim Seal [B]