Kawasaki STX-15F service manual Input Voltage Inspection, Be sure the battery is fully charged

3-28 FUEL SYSTEM (DFI)

Throttle Sensor (Service Code/Character-11/tPS)

•Adjust the throttle sensor positioning as follows. ○Install the air filter temporarily.

○After warming up the engine, check the idling speed.

Idle Speed

Standard: 1 300 ±100 r/min (rpm)

○Stop the engine and turn the ignition switch OFF.

○Disconnect the throttle sensor connector and connect the throttle sensor setting adapter [A] between the harness connector and throttle sensor connector.

○Connect a digital meter to the sensor setting adapter leads.

Special Tool - Throttle Sensor Setting Adapter: 57001 -1521

Throttle Sensor Output Voltage

Connections to Sensor

Meter (+)→ G/W lead

Meter (–)→ BK/W lead

○Start the engine with idle speed.

○Turn [A] the throttle sensor and bring the sensor output voltage within the standard range.

Output Voltage at Sensor

Standard: 1.08 ∼ 1.18 V DC (at idle throttle opening)

○Tighten the throttle sensor mounting screws.

Torque - Throttle Sensor Mounting Screws: 2.0 N·m (0.20 kgm·f, 18 in·lb)

○Recheck the sensor output voltage is within the standard range.

○Stop the engine and turn the ignition switch OFF.

○Remove the setting adapter and reconnect the throttle sensor connector.

Input Voltage Inspection

NOTE

○Be sure the battery is fully charged.

•Turn the ignition switch OFF.

•Remove the ECU (see ECU Removal). Do not disconnect the ECU connector.

•Connect a digital voltmeter [A] to the connector [B], using the needle adapter set.

Special Tool - Needle Adapter Set: 57001-1457

Throttle Sensor Input Voltage Connections to ECU

Meter (+)→ R lead (terminal 12) Meter (–)→ BK/W lead (terminal 8)