3-66 FUEL SYSTEM (DFI)

Throttle Lever, Cable and Case

Disassemble the throttle case.

Remove the circlip [A], flat washers [B], pin [C], throttle lever [D] and return spring [E] from the case [F].

Throttle Case Assembly/Installation

Insert the end of the return spring [A] in the throttle lever hole [B] and set the spring in the throttle case [C] as shown.

Install the control lever to the case.

Lubricate the throttle cable before assembly/installation.

Apply water resistant grease to the tips of the throttle ca- ble end.

Pulling the throttle cable [A], position the tips [B] of the cable end as shown.

Tighten the cable fitting nut.

Be sure the rubber cap [A] is in place on the throttle cable fitting nut end.

Cover the cable fitting nut [B] with the rubber boot [C].

Page 120
Image 120
Kawasaki STX-15F service manual Throttle Case Assembly/Installation