Kawasaki STX-15F service manual Magneto Flywheel Removal, Magneto Flywheel Installation

8-12 ENGINE BOTTOM END

Magneto Flywheel

Magneto Flywheel Removal

•Remove:

Engine (see Engine Removal/Installation chapter) Crankshaft Sensor Cover (see Electrical System chap- ter)

Coupling (see Coupling/Output Shaft Removal) Magneto Cover (see Coupling/Output Shaft Removal)

○Using the rotor puller [A], pull off the flywheel [B].

Special Tool - Rotor Puller: 57001-1623

Grip: 57001-1591 [C]

CAUTION

Do not hit the head of the rotor puller. A loss in rotor magnetism may be caused.

Magneto Flywheel Installation

•Using a high-flash points solvents, clean off any oil or dirt that may be on the crankshaft taper, and in the tapered hole in the magneto flywheel.

•Install the O-ring [A] directly as shown. ○This face [C] is magneto flywheel side.

•Fit the woodruff key [B] securely in the crankshaft before installing the magneto flywheel.

If the reduction gear [D] is removed, apply a molybdenum disulfide grease to both ends of its shaft.

•Install the reduction gear and the washer [E].