FUEL SYSTEM (DFI) 3-89

Fuel Tank

Remove the fuel tank [A] out of the hull as shown.

Fuel Tank Installation

Be sure the float [A] in place before putting the fuel tank into the hull.

Route the following correctly (see Cable, Wire, and Hose Routing section in Appendix chapter).

Fuel Hoses

Fuel Tank Vent Hose Fuel Level Sensor Leads

Other Wire and Harness

For JT1500-A2 model ; Replace the double spring clamps with new ones. (see Fuel System Diagram)

Fuel Tank Cleaning

Remove the fuel tank (see Fuel Tank Removal).

Drain the tank into a suitable container.

WARNING

Gasoline is extremely flammable and can be explo- sive under certain conditions. Pull the lanyard key off the stop button. Do not smoke. Make sure the area is well ventilated and free from any source of flame or spark; this includes any appliance with a pilot light.

Flush the tank repeatedly with high-flash-point solvent un- til it is clean. It may be necessary to put a few marbles or pieces of clean gravel into the tank and shake it, to knock loose any foreign matter in the bottom.

WARNING

Clean the tank in a well-ventilated area, and take ample care that there are no sparks or flame any- where near the working area; this includes any ap- pliance with a pilot light. Do not use gasoline or a low-flash point solvent to clean the tank. A fire or explosion could result.

Page 143
Image 143
Kawasaki STX-15F service manual Fuel Tank Installation, Fuel Tank Cleaning