Kawasaki STX-15F service manual Fuel Pump Installation, Power Source Voltage Inspection

FUEL SYSTEM (DFI) 3-85

Fuel Pump

Fuel Pump Installation

•Press down the rubber holder [A] onto the fuel pump [B] so the stepped part [C] of the holder completely contacts the flanged part [D] of the pump.

•Pressing down the rubber holder onto the fuel pump, tighten the small diameter clamp [E].

NOTE

○Install the rubber holder onto the fuel pump so the rub- ber holder top surface [F] must be below the top surface

[G]of the fuel pump to prevent any water from collect- ing on top of the pump.

•Install the O-ring [A] to the space between fuel pump [B] and rubber holder [C] so it completely contacts the flanged part [D] of the pump.

•Insert the fuel pump with rubber holder and O-ring into the tank so its fuel hose fittings face starboard side (see Ca- ble, Wire, and Hose Routing in Appendix chapter). And press down the pump so the O-ring [A] completely con- tacts the top surface of the tank [E].

•Tighten the large diameter clamp [F] securely.

•Install the following to the fuel pump. Fuel Hoses

Fuel Tank Vent Hose

Fuel Pump Lead Connector

○For JT1500-A2 model; Replace the double spring clamps with new ones. (see Fuel System Diagram)

NOTE

○The main fuel hose is larger than the return fuel hose.

Power Source Voltage Inspection

NOTE

○Be sure the battery is fully charged.