Kawasaki STX-15F service manual Multifunction Meter, Display Function Inspection

ELECTRICAL SYSTEM 14-57

Multifunction Meter

Display Function Inspection

•Using the auxiliary wires, connect the 12 V battery [A] to the meter unit [B] connector as follows.

JT1500-A2 model ∼ [C]

JT1500-A1 model [D]

○Connect the battery positive terminal to the terminal [1]. ○Connect the battery negative terminal to the terminal [2].

[1]R Battery (+)

[2]BK, Ground (−)

[3]R/BL, Speed Sensor

[4]R/W Ignition Switch (+)

[5]W/R, Fuel Level Sensor

[6]BL/BK, Diagnosis Signal

[7]GY, Tachometer Pulse

[8]G/R, Speed Sensor Pulse

[9]BK/W, Buzzer (−)

[10]R/BK, Buzzer (+)

[11]Y/BL, SLO (Smart Learning Operation) Mode

Battery Voltage Range: 10 ∼ 16 V

•When the positive terminal (+) of battery is connected to the terminal [4] completely, inspect that every LCD segment and LED warning light will be lit for several seconds just after disappearance of demonstrative fig- ure-expression.

•Check that when the terminals are disconnected , all the LCD segments and LED warning light disappear.

If the LCD segments and LED warning light will not ap- pear, replace the meter assembly.

[1]MODE Button

[2]SET Button

[3]Fuel Indicator

[4]Fuel Level Gauge

[5]Tachometer

[6]Speedometer

[7]“LED” Warning Light

[8]Engine Oil Pressure Indicator

[9]FI Indicator

[10]Low Battery Voltage Indicator

[11]Engine Cooling Water Temperature Indicator

[12]Multifunction Display

CAUTION

Do not drop the meter unit. Do not short the termi- nals.

If the multifunction meter displays incorrectly while the engine is running, first disconnect the (–) bat- tery terminal lead and reconnect it again to recover the meter display.

Then, check to see that the standard plugs and/or plug caps are installed. Install only the standard plugs and/or plug caps. The resistors are embed- ded in both parts.