. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message | Possible Cause | Suggested Solution |
|
|
|
“A problem with the hardware has been detected. (Timeout waiting for initial bus free phase.) Verify that SCSI cables are connected properly, and that the camera has a unique SCSI ID, and then try again.”
A problem with the camera hardware has been detected.
Verify that all SCSI connections are correct (if necessary turn off all equipment to alter the connections), make sure the camera has a unique SCSI ID, and try again.
“A SCSI error occurred.” | There may be one of a |
| variety of problems, |
| including loose or |
| incorrect cables, |
| improper SCSI |
| configuration, and so on. |
Shut down the computer, turn off the camera, and disconnect the camera from the computer and the AC battery charger/adapter. Check all SCSI connections and cables. Reconnect your equipment, restart, and try again.
“An item named itemname already exists in this location. Do you want to replace it with the one you’re copying?”
While working with an archive folder, you have selected an image, and clicked “Copy To;” however, an image with this filename already exists in the folder.
Click OK to replace the archive file with the selected file; or click Cancel and no replacement occurs.
If you click OK, sound files are replaced without notifying you.
“ASPI software for Windows has not been initialized. Install or reinstall the WINDOWS ASPI software.”
A problem has occurred with your software ASPI manager for Windows.
Install, or reinstall, the ASPI manager for Windows. This software, which is not available from Kodak, should be provided with your ASPI Windows host adapter card.
