. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.EOS•DCS 1 Only: Install the Calibration File.
A.Macintosh: Load the diskette with the calibration (CAL) file for your camera. Copy the calibration file (its name ends with the characters “.CAL”) into the folder containing your Photoshop
B.TWAIN (PC): Load the diskette with the calibration (CAL) file for your camera. Run the SETUP program to install the calibration file.
7.Attach the supplied AC battery charger/adapter.
Connect the adapter to a source supplying power within the range on its label, and to the connector on the lower left corner of the camera back. The first time it is used, allow the battery to charge for at least two hours shortly before it is used. Refer to Chapter 4. The section “Battery Charging for Optimal Capacity” in Chapter 7 includes important battery information.
8.Set the Camera SCSI ID.
Turn on the camera system by setting the power switch to on (I), push the camera back SCSI button once to enter SCSI mode, and then repeatedly to rotate through SCSI IDs. Stop at the desired ID. Do not select an ID that conflicts with any in use on your computer system. Refer to Chapter 4.
9.Connect the camera system to your Computer.
For this step we encourage all customers to refer to the detailed instructions in Chapter 4 to ensure that this connection is made properly before continuing. There you will turn off your computer, and connect the camera, a
Quick Start G
