. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Messages — KODAK Driver Software
The software driver designed by Kodak adds new messages to Photoshop. An explanation of those messages — listed in alphabetical order — follows.
NOTES: For an explanation of other Adobe Photoshop messages, refer to the instructions for that product.
Message | Possible Cause | Suggested Solution |
|
|
|
“A camera hardware error has been found. Verify that SCSI cables are connected properly, and that the camera has a unique SCSI ID, and then try again.”
A problem with the camera hardware has been detected.
Verify that all SCSI connections are correct (if necessary turn off all equipment to alter the connections), make sure the camera has a unique SCSI ID, and try again.
“A hardware error has been found in the SCSI cabling or connectors. Verify that SCSI cables are connected properly.”
A hardware error has been detected in the cabling or SCSI connectors.
Verify that all SCSI connections are correct (if necessary turn off all equipment to alter the connections). Try other cables if available. Be certain that terminators (if used with your computer setup) are still properly connected. Make sure terminator power is enabled on your SCSI card. If the problem persists, contact Kodak.
“A hardware error has occurred on an input- output device (not the camera).”
A hardware error was detected while trying to open or save an image to a storage device.
Service the peripheral to determine the cause of the problem.
