Kodak EOSDCS 5, EOSDCS 3, EOSDCS 1 user manual Pin Connector

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

B.If there is an external SCSI terminator between the end of a cable and a SCSI connector on a device, remove the terminator, and then reconnect the cable. (Later, if you remove the camera cable from your computer, remember to replace this terminator.)

5.Select the SCSI cable with the 50-pin connector at one end and the 25-pin connector at the other end.

IMPORTANT: Use only the cable supplied with the camera; do not use a substitute cable.

50-pin Connector 25-pin Connector

6.Connect the 50-pin connector to the empty connector on the last SCSI device in the chain. Make sure the connector is well seated by press- ing it into place firmly, and then pinch the thin wire clamps over its base.

25-pin Connector

50-pin Connector

 Preparing the Camera and the Computer G 4-19