
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message | Possible Cause | Suggested Solution |
|
|
|
“Command failure: | A problem has occurred | Restart your computer and try |
unable to free resource | with Windows. | again. |
from global memory. |
| If this does not resolve the |
Restart your computer and |
| |
| problem, obtain technical support | |
try again.” |
| |
| from your Windows supplier. | |
|
|
“Connect the adapter (if it is not already connected), and allow the adapter to charge the camera for three minutes before clicking the Load Camera Firmware button again.”
The battery does not have enough power to update the camera firmware.
Allow the camera battery to charge for three minutes from the AC battery charger/adapter, and then click the Load Camera Firmware button again.
“Data transfer from the | There has been an | Verify that the SCSI cable is |
camera to the computer | interruption in data | connected properly between the |
has been interrupted. | transfer between the | camera and the computer. If not, |
Verify that SCSI cables are | camera and the | turn both off, reconnect them, and |
connected properly.” | computer. | try again. |
“File Error: can not find the file WINASPI.DLL. Install or reinstall the
WINDOWS ASPI software, and remove other ASPI software if possible.”
The driver for ASPI is installed, but an ASPI compliant host adapter is not installed in the computer.
Obtain an ASPI compliant host adapter, have a technician install it, and then try again.
The TWAIN compliant KODAK Driver for ASPI is installed, as is an ASPI compliant host adapter, but the Windows ASPI files that accompany the ASPI compliant host adapter are not installed.
Install the Windows ASPI files that accompany the ASPI compliant SCSI host adapter, then try again.
If for some reason the Windows ASPI files were not supplied with your host adapter, contact the source of the host adapter to inquire about obtaining them.
Even though you may have installed ASPI files for other operating platforms (for example for DOS), the Windows ASPI files must be installed to use the KODAK Driver.