. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Making the SCSI Connection

The camera is a non-terminated SCSI device that connects to your Macintosh computer or PC with one of the included SCSI cables. In normal usage you may connect and disconnect the camera from the computer on a regular basis; for this reason you may want to position your computer so that its SCSI connector is readily accessible.

Three sets of instructions follow.

I.The camera is the sole SCSI device.

IIThe camera is used with other SCSI devices.

NOTE: You may need to obtain a SCSI terminator to complete these steps if other external SCSI devices are connected to your computer. A single 25-pin SCSI terminator is supplied with the camera.

III. The camera is used with a Macintosh PowerBook or a PC laptop.

Read the section that matches the environment in which you will use the camera

I. Camera as the Sole SCSI Device

Follow these steps if you will connect the camera as the sole external SCSI device attached to your computer

1.Turn off the camera and the computer.

IMPORTANT: Later when you connect and disconnect the computer and the camera on a regular basis, make sure that the computer is off.

2.Place the camera in a convenient position next to your computer.

 Preparing the Camera and the Computer G 4-13

Page 57
Image 57
Kodak EOSDCS 5, EOSDCS 3, EOSDCS 1 user manual Making the Scsi Connection, Camera as the Sole Scsi Device