Section 6 Various Settings and Registration
Turning 2 in 1 Reception ON/OFF
If 2 in 1 reception is turned ON and two 5 1/2" x 8 1/2" [A5] size pages are received in a row during the same reception, those 2 pages will be printed onto a single sheet of 11" x 8 1/2" [A4R] size paper. In order to accomplish 2 in 1 Reception, it is necessary to turn this function ON here in advance.
*2 in 1 Reception will not be available when both 2 in 1 Reception and Duplex Reception are turned ON.
*If you want to cancel the procedure part way through, press the Reset key. The touch panel will return to the initial mode settings.
1.Press the Default key. The Default Setting screen will appear.
(Inch)
(Metric)
2.Touch the “Fax default” key.
3.Touch the “▼” cursor key until “2 in 1 RX” is highlighted.
4.Touch the “Change #” key.
(Inch)
(Metric)
5.Select whether you want to turn 2 in 1 Reception ON or OFF by touching either the “On” or “Off” key, as appropriate.
6.Touch the “Close” key. If you are finished making settings, press the Reset key.
Turning Remote Diagnosis ON/OFF
Especially if trouble occurs in this fax in which it is necessary to call for service, it is possible for our service center computer to access the fax directly over the telephone line and check its status and other information about the trouble.
*To use Remote Diagnosis, it is necessary to enter into a contract with an authorized service center in advance and also to register a predetermined Remote Test ID in advance. (Refer to "Registering the Remote test ID" on page
*If you want to cancel the procedure part way through, press the Reset key. The touch panel will return to the initial mode settings.
1.Press the Default key. The Default Setting screen will appear.
(Inch)
(Metric)
2.Touch the “Fax default” key.
3.Touch the “▼” cursor key until “Remote Diag.” [“Remote diagn.”] is highlighted.
4.Touch the “Change #” key.
(Inch)
(Metric)
5.Select whether you want to turn Remote Diagnosis ON or OFF by touching either the “On” or “Off” key, as appropriate.
6.Touch the “Close” key. If you are finished making settings, press the Reset key.
