Section 1 Fax Operation (Basic Use)
Canceling a Communication
You can cancel a communication even if it is already in progress. The methods for canceling a communication differ depending on whether that communication is a fax transmission or a fax reception, and whether that transmission was initiated using the Memory Transmission mode or the Direct Feed Transmission mode. The following contains explanations on the various methods used for canceling communications.
(1) Canceling a Memory Transmission (during scanning)
If you want to cancel a Memory Transmission during scanning of the documents, simply press the Stop/Clear key. The document that is currently being scanned will be ejected and the touch panel will return to the initial mode settings. If there are any documents left in the Document Processor, remove them from the document table.
(2) Canceling a Memory Transmission (during transmission)
If you want to cancel a Memory Transmission in which scanning all of the documents has been completed and the dialing or transmission operation has already begun, perform the following procedure.
(Inch)
(Metric)
Touch the “Status” [“Act status”] key in the bottom right of the
1 touch panel.
The status of the communication currently in progress will appear in the message display.
(Inch)
(Metric)
2 | Touch the “Stop” key or press the Stop/Clear key. The touch |
panel will return to the initial mode settings. |
*If you attempt to cancel a transmission that is scheduled to multiple destinations (such as a Broadcast Transmission) and there were destinations still remaining to be transmitted to, a message will appear in the message display asking whether or not you want to continue the transmissions to the remaining destinations.
(3)Canceling a Direct Feed Transmission
A message such as that shown below will be displayed after dialing the destination party in the Direct Feed Transmission mode.
If you want to cancel a Direct Feed Transmission, touch the “Stop” key or press the Stop/Clear key. When a display to confirm the cancel appears, touch the “Yes” key. The document that is currently being scanned will be ejected and the touch panel will return to the initial mode settings. If there are any documents left in the Document Processor, remove them from the document table.
(Inch)
(Metric)
