Section 8 OPTIONAL EQUIPMENT

Setting originals in the SRDF

1Adjust the original insert guides to fit the width of original(s) to be copied.

NOTES

Before copying, make sure that there are no originals remaining on the original eject table. Originals left on the eject table can cause other originals to misfeed.

IMPORTANT!

Be sure to set only a number of originals that is LESS than the level indicator on inside of the rear insert guide. Also, DO NOT set originals outside the acceptable range as this can cause the originals to misfeed.

(See page 8-1 for details on acceptable originals.)

To keep ejected originals from falling off the copier, open the ejection extension when using larger sized originals such as 8 1/2" x 14" and 11" x 17" [B4 and A3].

If you are setting multiple originals at one time, ALWAYS use originals of the same size. It is, however, possible to use different size originals of the same width (ex.: 11" x 8 1/2" and 11" x 17" [A4 and A3]) at the same time if you use the auto selection mode. See page 8-3.)

2

Arrange the originals in order and set them face up (front

side up for 2-sided copies) on the original table. The original

set indicator will light green. If the indicator doesn’t light, set the originals once again.

When copying from 2-sided originals, the originals will be temporarily ejected from the left cover in order to turn them over and copy the reverse side. Do NOT touch them at this point! Any attempt to remove them can cause the originals to misfeed.

8-2

Page 129
Image 129
Kyocera KM-C830D manual Optional Equipment, Setting originals in the Srdf