Kyocera KM-C830D manual Making copies with clean edges Border erase modes

Section 6 FUNCTIONS

6. Making copies with clean edges [Border erase modes]

NOTE (3) Selecting the erasing area (Custom erase mode)

If you do not have a Memory Copy Board installed as standard equipment, the optional Memory Copy Board must be installed in your copier in order to use this mode.

With this mode, you can make clean, blemish-free copies from non- standard size originals, i.e. sizes other than 8 1/2" x 11", 11" x 17" [A4, B4], etc. (The width of the border that will be erased is shown as a in the illustration.)

(1)Erasing blemishes from edges of copies (Sheet erase mode)

With this mode, shadows, lines, etc., that occur around the edges of copies made from sheet originals can be erased. (The erased border width is shown as a in the illustration.)

NOTES

•The width of the border to be erased can be set to either 1/4", 1/2" or 3/4" [6 mm, 12 mm or 18 mm].

•It is possible for you to change the default setting for the width of the erased border. (See “^ Erased border width” on page 7-20.)

(2)Erasing blemishes from the edges and middle of copies made from books (Book erase mode)

With this mode, you can make clean copies, even from thick books. (The erased border width is shown as a in the illustration.)

NOTES

•The size of the original that is being copied must be registered in advance. (See “& Custom erase size” on page 7-21.)

•The illustration above shows how copies will be created when the original is set on the platen.

1 Set the original to be copied.

NOTE

Set book originals as shown in the illustration.

NOTES

•The width of the border to be erased can be set to either 1/4", 1/2" or 3/4" [6 mm, 12 mm or 18 mm].

•It is possible for you to change the default setting for the width of the erased border. (See “^ Erased border width” on page 7-20.)

6-15