Kyocera KM-C830D manual Insert tray

Section 7 COPIER MANAGEMENT

Default setting	Description	Available settings	Factory	Reference
			setting	page
* Insert tray	Sets the drawer that contains the paper which will be	Standard copiers	2 paper	7-21
	fed in the insert sheet modes (page 6-26).	1 paper [SOURCE 1] –	[SOURCE 2]
	* No.3 and No.4 drawers can only be selected when	4 paper [SOURCE 4] /
	the optional Paper Feeder is installed in your	Bypass
	copier.
		Duplex copiers
		2 paper [SOURCE 2] –
		4 paper [SOURCE 4] /
		Bypass
( Sort mode ON/OFF	Sets the default setting for the sort mode at the time	On / Off	Off	7-21
(Output form)	power is turned on.
) Eject destination	Sets the location for ejection of finished copies: the	Inner Eject / Side Eject	Inner Eject	7-22
	copy eject tray (side) or the copy storage table
	(inner).
⁄ ACS adjustment	Adjusts the level of detection between color and	1 – 5	1	7-22
	black&white originals in the Auto Color Selection
	mode (page 4-1).
¤ Auto color	Slight changes in color copying may take place if	---	---	7-22
adjustment	your color copier is used over a long period of time.
	If the color on the originals and that which appears
	on the copies begins to differ greatly, use this
	procedure to adjust the color.
‹ Drum refresh	This operation should be performed when high	---	---	7-23
	humidity causes the copy image to become blurred
	or faded. The operation will take approximately 5
	minutes.
› Rotate sort ON/OFF	Selects between standard sorting (page 6-46) or	On / Off	Off	7-23
	rotate-sorting (page 6-46) as the default sort mode
	whenever the sort mode is selected.
	* In order to use this setting, there must be
	11" x 8 1/2 and 8 1/2" x 11" [B5 and B5R or A4 and
	A4R] paper set in the drawers. (8 1/2" x 11" and
	A4R paper can be loaded into the optional Paper
	Feeder, while B5 paper can be set onto the multi-
	bypass tray. However, 2-sided copies cannot be
	made automatically when paper is being fed from
	the multi-bypass tray.)

7-15