Troubleshooting

272

Standard USB port disabled [56]

Try one or more of the following:

From the printer control panel, touch Continue to clear the message.

Enable the USB port. From the printer control panel, navigate to: Network/Ports > USB Buffer > Auto

Note: The printer discards any data received through the USB port.

Supply needed to complete job

Do either of the following:

Install the missing supply to complete the job.

Cancel the current job.

Too many flash options installed [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra flash memory.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Too many trays attached [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra trays.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Unformatted flash detected [53]

Try one or more of the following:

From the printer control panel, touch Continue to stop the defragmentation and continue printing.

Format the flash memory.

Note: If the error message remains, then the flash memory may be defective and needs to be replaced.

Unsupported disk

Remove the unsupported printer hard disk, and then insert a supported one.

Page 272
Image 272
Lexmark XM3100 manual Standard USB port disabled, Supply needed to complete job, Too many flash options installed