Lexmark XM3100 manual Miscellaneous Security Settings menu, Understanding the printer menus 162

Understanding the printer menus 162

Miscellaneous Security Settings menu

Use	To
Login Restrictions	Limit the number and time frames of failed login attempts from the printer control
Login failures	panel before all users are locked out.
Failure time frame	Notes:
Lockout time	• “Login failures” specifies the number of failed login attempts before users are
Panel Login Timeout
	locked out. Settings range from 1 to 10 attempts is the factory default setting.
Remote Login Timeout
	• “Failure time frame” specifies the time frame during which failed login
	attempts can be made before users are locked out. Settings range from 1 to 60
	minutes. 5 minutes is the factory default setting.
	• “Lockout time” specifies how long users are locked out after exceeding the
	login failures limit. Settings range from 1 to 60 minutes. 5 minutes is the
	factory default setting. 1 indicates the printer does not impose a lockout time.
	• “Panel Login Timeout” specifies how long the printer remains idle on the
	Home screen before automatically logging the user off. Settings range from 1
	to 900 seconds. 30 seconds is the factory default setting.
	• “Remote Login Timeout” specifies how long a remote interface remains idle
	before automatically logging the user off. Settings range from 1 to 120
	seconds. 10 minutes is the factory default setting.
Security Reset Jumper	Change the value of the security settings.
Access controls=”No Security”	Notes:
No Effect
	• Access controls=”No Security” retains all the security information that the user
Reset factory security defaults
	has defined. “No Security" is the factory default setting.
	• “No Effect” means the reset has no effect on the device’s security
	configuration.
	• “Reset factory security defaults” deletes all security information that the user
	has defined, and assigns the factory default value to each setting in the
	Miscellaneous Security Settings section of both the panel and the Embedded
	Web Server.
LDAP Certificate Verification	Allow the user to request a server certificate.
Demand	Notes:
Try
	• “Demand” means a server certificate is requested. If a bad certificate is
Allow
	provided or if no certificate is provided, then the session is terminated
Never
	immediately. “Demand” is the factory default setting.
	• “Try” means a server certificate is requested. If no certificate is provided, then
	the session proceeds normally. If a bad certificate is provided, then the session
	is terminated immediately.
	• “Allow” means a server certificate is requested. If no certificate is provided,
	then the session proceeds normally. If a bad certificate is provided, then it will
	be ignored, and then the session proceeds normally.
	• “Never” means no server certificate is requested.
Minimum PIN Length	Limit the digit length of the PIN.
1–16	Note: 4 is the is the factory default setting.