Additional printer setup

44

Removing a printer hard disk

Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity. Touch something metal on the printer before touching any controller board electronic components or connectors.

1Access the controller board.

For more information, see “Accessing the controller board” on page 30. Note: This task requires a flathead screwdriver.

2Loosen the screws that connect the printer hard disk to the controller board bracket.

3Unplug the printer hard disk interface cable from the receptacle in the controller board , leaving the cable attached to the printer hard disk. To unplug the cable, squeeze the paddle at the plug of the interface cable to disengage the latch before pulling the cable out.

4Hold the printer hard disk by the edges, and then remove it from the printer.

5Close the controller board shield, and then close the access door.

Page 44
Image 44
Lexmark XM3100 manual Removing a printer hard disk, Additional printer setup