Master TOC
|
TROUBLESHOOTING & REPAIR
INPUT RECTIFIER REMOVAL AND REPLACEMENT (continued)
Return to
Return to Section TOC
Return to Section TOC
Return to
Return to Master TOC
Return to Master TOC
10.With the 5 mm Allen wrench and the 10 mm open end wrench, remove the two screws mounting the input rectifier to the heat sink panel.
11.When replacing the input rectifier, apply a thin, even coating of Dow Corning 340 Joint Compound (Lincoln T12837) to the mating surfaces between the input rectifi- er and the heat sink panel. Avoid applying the compound to either the mounting holes or the mounting hardware.
12.Mount the input rectifier to the heat sink panel and tighten the two mounting screws with the 5 mm Allen wrench and the 10 mm open end wrench. Be sure to tighten the screws evenly.
13.With the Phillips head screw driver, attach the positive (+) and negative
14.Apply silicone sealant to the M.O.V. assembly connections.
15.Install the machine case sides and top.
16.Install the handle and the lift bail rubber gasket.
Return to Section TOC
Return to Master TOC
