Return to Section TOC
Return to Section TOC
Section TOC
Return to Master TOC
Return to Master TOC
Master TOC
TROUBLESHOOTING & REPAIR
PRINTED CIRCUIT BOARD REMOVAL AND REPLACEMENT
(CONTROL BOARD, POWER BOARD, AND PROTECTION BOARD) (continued)
FIGURE F.66 - PC BOARD REMOVAL
1
2
1. PC BOARD COVER
2. PC BOARD ASSEMBLY
3. RETAINER CLIPS
3
Return to
Return to Section TOC
Return to
Return to Master TOC
PROCEDURE
1.Remove main input supply power to the machine.
2.With the 3/8" nut driver, remove the 4 screws that hold the handle to the machine.
3.Remove the rubber gasket (cover seal) from the lift bail.
4.With the 5/16" nut driver, remove the sheet metal screws from the case top.
5.With the 5/16" nut driver, remove the screws holding the right and left case sides. Remove the case sides by lifting up and out.
6.Perform the Capacitor Discharge Procedure described earlier in this section of the manual.
WARNING
Before continuing with the test procedure, perform the capacitor discharge proce- dure to avoid electric shock.
7.After you have completed the capacitor dis- charge procedure for all four switch boards, use the 5/16" nut driver to remove the two screws holding the printed circuit board cover in place. Slide the cover forward and lift up to remove it.
