
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
ACCESSORIES | |||||||
| CONNECTION OF THE | 5. | Attach the single lead from the | ||||
| RANGER 305D “ACROSS THE ARC” |
| lead. This is only a control lead - it carries no |
| |||
| (SEE FIGURE C.2.) |
|
| to the work using the spring clip on the end of the | |||
|
| 6. | welding current. |
| |||
1. | Shut the welder off. |
| Place the “IDLER” switch in the “AUTO” or “HIGH” | ||||
2. | Connect the electrode cable from the |
| position as desired. |
| |||
|
| to the “+” terminal of the welder. |
|
| CAUTION |
| |
|
| If | you are using an | ||||
| NOTE: Figure C.2 shows the electrode connected for | ||||||
| tor, the electrode will be “HOT” when the Ranger |
| |||||
| negative polarity. To change polarity, shut the welder | 305D is started. |
| ||||
| off and reverse the electrode and work cables at the | ||||||
| Ranger 305D output terminals. |
| 7. | Place the “WELD TERMINALS” switch in the |
| ||
| NOTE: Welding cable must be sized for current and |
| |||||
|
| “WELD TERMINALS ON” position. |
| ||||
| duty cycle of application. |
| 8. | Adjust wire feed speed at the | |||
3. | Set the “VOLTMETER” switch to “+” or | ||||||
| welding voltage with the output “CONTROL” at the | ||||||
4. | ing on the polarity chosen. |
| 9. |
| |||
Set the “MODE” switch to the | Set the ARC control to “0” initially and adjust to |
| |||||
|
|
|
|
| suit. |
|
FIGURE C.2 - Ranger 305D/LN-25 ACROSS THE ARC CONNECTION DIAGRAM
| OPTIONAL |
| ||
AMPHENOL | - | AMPHENOL | REMOTE CONTROL |
|
+ |
|
| ||
| WIRE FEEDER | WORK CLIP LEAD | ||
|
| |||
|
| TO WORK |
| TO WORK |
|
|
|
| |
|
|
| ELECTRODE CABLE |
|