3 - 39
3. CC-LINK COMMUNICATION FUNCTIONS
(2) When setting the position command data/poi nt table No. (speed command)
Specify the position address with the remote r egister, and specify the speed command data by specif ying
the point table No. to use the preset servo motor s peed, acceleration time constant and deceleration time
constant the speed command data, and execute positioning.
Preset " 1" in parameter No.PC30 to enable position com mand data-set and point table No. (speed
instruction)-setting operation.
Position instruction
execution completion
(RX(n+2)0)
Forward rotation
Reverse rotation
start
(RYn1 RYn2)
Speed instruction
demand
(RY(n+2)1)
Position data setting
Point table No.
designation
6ms
ON
OFF
ON
OFF
ON
OFF
Position instruction data
Lower 16bit (RWwn+4)
Point table No.
(RWwn+6)
Speed instruction
execution completion
(RX(n+2)1)
ON
OFF
Position instruction
demand
(RY(n+2)0)
ON
OFF
Position instruction data
Upper 16bit (RWwn+5)
(Note) Data reserved
Respond code
(RWrn+2)
Note. This data is stored into RAM of the servo amplifier. Hence, the data is cleared when power is switched off.
Set the lower 16 bits of the position instruc tion data to Position instruction data lower 16 b it (RWwn+4), the
upper 16 bits of the position instruction data to P osition instruction data upper 16 bit (RWwn+5), and point
table for speed command No. to point table No. (RW wn+6), and turn Position instruction demand
(RY(n+2)0) and Speed instruction demand (RY( n+2)1) to ON.
Turning RY(n+2)0 and RY(n+2)1 to ON stores the position comm and data and point table No. into RAM of
the servo amplifier.
When the data are stored, Position instructio n execution completion (RX(n+2)0) and Speed instruction
execution completion (RX(n+2)1) turn to ON.
If data outside the setting range is set to any of Position instruction data lower 16 bit (RWwn+4), Position
instruction data upper 16 bit (RWwn+5) and poin t table No. (RWwn+6), the error code (refer to section
3.5.5) is set to respond code.
Turn Forward rotation start (RYn1) Reverse rotation start (RYn2) to ON after Position instr uction execution
completion (RX(n+2)0) and Speed instructio n execution completion (RX(n+2)1) have turned to ON.