14 - 36
14. OPTIONS AND AUXILIARY EQUIPMENT
17
5
EMG
DOCOM
DICOM
ALM
1
NFB
(Note 12)
ALM
RA1
MC
SK
MC
ON
OFFEMG
Servo motor
thermal relay
RA2
(Note 7)
(Note 1)
Power
supply
N/
P/
BUE
SD
PR
B
C
A
SD
MSG
(Note 4)
(Note 6)
P1
P2
P( )
N( )
C
FR-BU2-(H)
FR-BR
Servo amplifier
P
PR TH2
TH1
(Note 5)
MC
Terminal
block
(Note 3)
(Note 11)
(Note 2)
(Note 8)
(Note 12)
CN6
L1
L2
L3
L11
L21
(Note 10)
(Note 9)
N/
P/
BUE
SD
PR
B
C
A
SD
MSG
FR-BU2-(H)
(Note 5)
FR-BR
P
PR
24VDC
RA1
TH2
TH1
(Note 4)
(Note 6)
(Note 10)
(Note 9)

Note 1. For power supply specifications, refer to section 1.2.

2. For the servo amplifier of 5k and 7kW, always disconnect the lead of built-in regenerative resistor, which is connected to the P

and C terminals. For the servo amplifier of 11k and 15kW, do not connect a supplied regenerative resistor to the P and C

terminals.

3. Always connect P1 and P2 terminals (P1 and P for the servo amplifier of 11k and 15kW) (Factory-wired). When using the power

factor improving DC reactor, refer to section 14.11.

4. Connect the P/ and N/ terminals of the brake unit to a correct destination. Wrong connection results in servo amplifier and

brake unit malfunction.

5. Contact rating: 1b contact, 110VAC_5A/220VAC_3A

Normal condition: TH1-TH2 is conducting. Abnormal condition: TH1-TH2 is not conducting.

6. Contact rating: 230VAC_0.3A/30VDC_0.3A

Normal condition: B-C is conducting/A-C is not conducting. Abnormal condition: B-C is not conducting/A-C is conducting.

7. For the servo amplifier of 11kW or more, connect the thermal relay censor of the servo amplifier.

8. Do not connect more than one cable to each P and N terminals of the servo amplifier.

9. Always connect BUE and SD terminals (Factory-wired).

10. Connect the MSG and SD terminals of the brake unit to a correct destination. Wrong connection results in servo amplifier and

brake unit malfunction.

11. For the cable to connect the terminal block and the P and N terminals of the servo amplifier, use the cable indicated in (4) (b) in

this section.

12. The diagram is for when outputting the trouble (ALM) is enabled by changing the parameter. When disabling to output the

trouble (ALM), configure the power supply circuit to turn off the magnetic contactor after detecting an alarm occurrence on the

controller side.