2 - 1
2. INSTALLATION 2. INSTALLATION
CAUTION
Stacking in excess of the limited number of pr oducts is not allowed.
Install the equipment on incombustible material. Inst alling them directly or close to
combustibles will lead to a fire.
Install the equipment in a load-bearing place in accordance with this Instruction
Manual.
Do not get on or put heavy load on the equipment to prevent injury.
Use the equipment within the specified environmental condition range. (For the
environmental conditions, refer to section 1 .2.)
Provide an adequate protection to prevent screws, m etallic detritus and other
conductive matter or oil and other combustib le matter from entering the servo
amplifier.
Do not block the intake/exhaust ports of the servo amplif ier. Otherwise, a fault may
occur.
Do not subject the servo amplifier to drop impact or shoc k loads as they are
precision equipment.
Do not install or operate a faulty servo amplifier.
When the product has been stored for an extended p eriod of time, consult
Mitsubishi.
When treating the servo amplifier, be carefu l about the edged parts such as the
corners of the servo amplifier.
2.1 Installation direction and clearances
CAUTION
The equipment must be installed in the specified dir ection. Otherwise, a fault may
occur.
Leave specified clearances between the servo am plifier and control box inside
walls or other equipment.
(1) 7kW or less
(a) Installation of one servo amplifier
10mm
or more
10mm
or more
Control box
40mm
or more
Servo amplifier
40mm
or more
Wiring allowance
80mm
or more
Control box
Top
Bottom