Converting the System Pedestal Unit
Converting your pedestal system to a rack mounted unit consists of:
removing the top and side covers
removing the bezel frame
installing a new bezel frame
installing handles
Tattaching slide rails to the chassis preparing the rack.
After the system unit is converted to a rack unit, install the unit in the rack (see “Installing the Unit in the Rack” later in this chapter).
Removing the System Unit Covers
Remove the one piece system unit top and side cover as follows.
1.Power down the system, disconnect any peripheral devices, and unplug all power cords.
2.At the back of the system unit, remove and save the screw from the top cover (see the following figure).
Removing the Cover Screws
