NEC MH4500 manual Using the Symbios Scsi Utility, Exit Menu, Running the Symbios Scsi Utility

Exit Menu

You can make the following selections on the Exit Menu. Select an option using the up or down arrow keys, then press Enter to execute the option. Pressing Esc does not exit this menu. You must select one of the items from the menu or menu bar to exit.

	Exit Menu
Choices	Description
Exit Saving Changes	Exits after writing all modified Setup item values to CMOS.
Exit Discarding Changes	Exits leaving CMOS unmodified.
Load Setup Defaults	Loads default values for all Setup items.
Load Custom Defaults	Loads settings from custom defaults.
Save Custom Defaults	Saves present Setup values to custom defaults.

	!		CAUTION
		Verify that custom defaults are saved
		before exiting. Failure to do so can
		result in system malfunction.
Discard Changes	Reads the previous value of all Setup items from CMOS.
Save Changes	Writes all Setup item values to CMOS.

Using the Symbios SCSI Utility

The Symbios SCSI Utility detects the SCSI host adapter located on the system board. Use the utility to:

change adapter and SCSI device default values

check and/or change SCSI device settings that may conflict with those of

Tother devices in the server

perform low-level formatting or verify operations on SCSI disk drives.

Running the Symbios SCSI Utility

1.Power-on the system. The system boots up.

2.When this message appears on the video monitor

Press Ctrl-C to start the Symbios SCSI Utility

Press Ctrl+C to run the utility.

3.The utility starts and the Main Menu displays.

3-16 Configuring Your System