NEC MH4500 manual Replacing the Bezel Frame Setting Up Your System

3.Grasp the built-in handle on the back of the cover and, using an even pull, slide the cover back about an inch until it stops.

4.Pull the cover straight up and off the chassis. Set the cover aside.

5.Remove and save the two screws holding the access (side) panel in place.

6.Grasp the built-in handle on the back of the access panel and, using an even pull, slide the cover back about an inch until it stops.

7.Pull the cover straight away from the chassis and set aside.

Replacing the Bezel Frame

The bezel frame must be replaced with a new bezel frame containing cutouts for two chassis handles. Remove the bezel frame from the system unit and replace it with a new bezel frame as follows.

1.Open the bezel door all the way to the left (as you face the unit) and lift the door up slightly to free it from the bezel frame, then remove from the frame.

2.Remove the bezel frame by pressing its seven retaining tabs toward the center of the chassis while pulling the frame away (see the following figure).

B

A

A.Bezel Frame

B.Frame Tabs (7)

Replacing the Bezel Frame

Setting Up Your System 2-13