
A
Removing the EMI Shield
!CAUTION
Observe static precautions. Use an antistatic wrist strap.
4.Remove the device from its protective wrapper and place it on an antistatic surface. Record the device model and serial number in the equipment log.
5.Set any device jumpers or switches before you install the device. See the documentation that comes with the device for jumper or switch information.
Note: If the device comes with device rails, do not use them. Remove any rails already attached. Use only the rails in the accessory pack that comes with your system.
6.Remove the two rails and four mounting screws from your accessory pack and attach them to the device.
TPosition the device and rails as shown in the following figure. Secure the rails to the device with the four screws.