Controller/Adapter Hardware Configurations
The following table lists the option boards you may add to your system that require specific installation slots.
Option Board Hardware Configurations
|
| Memory |
|
|
Option Board | IRQ | Address | I/O Address | Option Slot |
|
|
|
|
|
Mylex | Set by | Set by | Set by BIOS | PCI Slot B2 (see PCI/ISA |
AcceleRAID 250 | BIOS | BIOS |
| Slot Location illustration |
(SecuRAID 210) |
|
|
| above) |
Controller Board |
|
|
|
|
Mylex AcceleRAID 1100 (SecuRAID
530)Controller Board
Installing an Option Board
Install an option board as follows.
1.Power off the system, disconnect any peripherals, and unplug the AC power cords from power.
2.Remove the access cover as previously described.
3.Remove the foam cover from the electronics bay.
4.Remove an expansion slot screw and cover (see the following figure).
!CAUTION
Observe static precautions. Use an antistatic wrist strap.
5.Hold the option board by its edges and remove it from its protective wrapper. Do not touch board components or connectors.
6.Set the board down on an antistatic surface.
7.Record the option board serial number in the equipment log.
