3.Align the bracket behind the rack’s vertical edge and behind the mounting holes in the vertical edge (see the following figure).
1
2
4
3
1.Screw
2.Rack Vertical Rail
3.Bar Nut
4.Right angle Extension Bracket
Installing the Extension Brackets
4.Determine where you want to attach the bracket on the rack’s vertical rail.
When determining where to attach the bracket, be sure to allow space
Tfor additional units.
Mark, with a pencil, the bracket top and bottom hole locations on the rail.
5.Insert a screw through the marked top hole in the vertical rail and through the top hole in the extension bracket.
6.Place a bar nut over the screw and loosely thread the screw into the bar nut.
7.Insert a screw through the marked bottom hole in the vertical rail and extension bracket and loosely thread the screw into the bar nut.
8.Install the remaining three extension brackets, bar nuts, and screws.
Before installing, carefully align each bracket in exactly the same
Tvertical position as the first bracket.
After installing, check that the brackets are vertically aligned and level with each other.
9.Tighten all the screws holding the brackets to the rack.
Installing the Slider Assemblies
Use the following procedure to install each slider assembly on the extension brackets in the rack. Refer to the following figure while performing the procedure.
