A.Bezel Frame
B.Rectangular Cutout
C.Chassis Handle
D.Screws
Attaching the Chassis Handles
Attaching the Outer Slide Bars to the Chassis
Note: If you have a rack unit, you must use the following procedure to attach the slide bars before mounting the unit in the rack. Observe all safety precautions, warnings, and cautions noted throughout this chapter.
Each slide assembly consists of a large outer bar, a center bar, and a small outer bar. The large outer bar and the center bar attach to the rack unit. The small outer bar attaches to the system chassis. As the slide assembly ships as an assembled unit, you must remove the small outer bar from the assembly before attaching to the chassis.
Remove the small outer bar from each slide assembly and attach each bar to the chassis as follows.
1.Position the slide assembly on a flat surface with the small outer bar down.
2.Fully extend the three telescoping bars until they lock in place (see the following figure).
