
4.Carefully slide the center bar (6) towards the back of the rack until the oblong hole in the bar is over the third hole from the front of the large outer bar (4).
Insert an
Place a flat washer, lock washer, and a
5.Secure the back end of the large outer bar (4) to the back extension bracket (1).
The end of the outer bar has four holes. The extension bracket has two holes and two elongated slots for fastening the bar.
Align two holes in the outer bar with a hole and slot in the bracket.
Which holes/slots you use depends on the depth of the rack.
Insert an
Tthrough the hole and slot in the extension bracket.
Place a flat washer, lock washer, and a
6.Check that the bars and brackets are positioned correctly in the rack.
7.Tighten all the screws holding the bars to the extension brackets and rack.
Installing the Rack Unit in the Rack
Note: If you have a rack unit, you must use the following procedure to install the unit in the rack. Observe all safety precautions, warnings, and cautions noted throughout the procedures.
Install your converted unit (or rack unit) in the rack as follows.