NEC MH4500 manual Installing the Slider Assembly

1 2 2

4 5 6

3

2

7

4 2 6

2

1.Back Extension Bracket

2.8-32 Screw

3.Flat Washer, Lock Washer, and 8-32 Nut

4.Large Outer Bar

5.Safety Latch on Center Bar

6.Center Bar

7.Front Extension Bracket

Installing the Slider Assembly

1.With the safety latch (5 on the above figure) end of the slider assembly towards the back of the rack, press the flat side of the slider assembly into the U-shaped sections of the previously installed extension

brackets (1 and 7).

2.Slide the slider assembly towards the front of the rack until the end of the large outer bar (4) is flush with the end of the U-shaped section of the front extension bracket (7).

3.Carefully slide the center bar (6) towards the front of the rack until the oblong hole in the bar is over the first hole in the large outer bar (4).

Insert a 8-32 screw through the oblong hole in the center bar, the hole in

Tthe large outer bar, and into the first hole in the front extension bracket.

Place a flat washer, lock washer, and a 8-32 nut on the screw and loosely tighten.

2-20 Setting Up Your System