Overland Storage REO 9000 Positioning the REO Appliance in a Rack, To install the unit in a rack

Setup Guide

Positioning the REO Appliance in a Rack

Caution: Due to the weight of each rack-mounted unit when it is fully extended, you should install units from the bottom up. Extending a unit that has empty spaces beneath it might cause the rack to tip forward or might cause personal injury. Overland Storage recommends that two people support and slide the unit in the rack.

Vorsicht: Aufgrund des Gewichtes eines Gerätes, welches für den Einbau in ein Rack gedacht ist, empfehlen wir Ihnen, dieses von unten nach oben in das Rack zu installieren. Wenn Sie ein Gerät aus dem Rack heraus ziehen, könnte es Ihnen entgleiten und so zu Verletzungen führen. Wir empfehlen den Ein- und Ausbau des Gerätes durch zwei Personen.

To install the unit in a rack

1Separate each set of slides as follows:

„Pull the outer slide toward the rear, along with the intermediate slide, until the inner slide-lock engages the intermediate slide.

REO90002

„Continue to pull the outer slide towards the rear until the outer slide- lock engages the intermediate slide. To permit the intermediate slide to continue to move toward the rear, press the inner slide-lock button. Continue to move the outer and intermediate slides toward the rear until they are separated from the inner slide.

REO90005

Positioning the REO Appliance in a Rack W 21