Appendix

Appendix

You cannot position your vehicle on the map or the positioning error is large.

Something covers the GPS antenna. Do not cover the GPS antenna with spray paint or vehicle wax, because this may block the reception of GPS signals. Snow buildup can also degrade the signals.

Signals from the vehicle’s speed Check that the cables are properly connected. pulse are not being picked up prop- If necessary, consult the dealer that installed

erly.

the system.

The navigation system may not be

Check that the navigation system is securely

mounted securely in your vehicle.

mounted and, if necessary, consult the dealer

 

that installed the system.

 

 

 

Your vehicle is operating in Simple

Connect the speed signal input (pink lead

 

hybrid mode.

wire) of the power cable correctly, and reset

 

 

the 3D Hybrid Sensor memory ([Learning

 

 

Status]).

 

 

 

 

The navigation system is installed

Confirm the installation angle. (The naviga-

 

with an extreme angle exceeding

tion system must be installed within the al-

 

the limitation of the installation

lowed installation angle. For details, refer to

 

angle.

“Installation Manual”.)

 

 

 

 

Indication of the position of your ve-

Check whether or not the reverse gear signal

 

hicle is misaligned after a U-turn or

input lead (violet) is connected properly. (The

 

reversing.

navigation system works properly without the

 

 

lead connected, but positioning accuracy will

 

 

be adversely affected.)

 

 

 

The map continually reorients it-

The traveling direction is set to

Touch on the screen and change the map

self.

Heading up.

display.

 

 

 

Tracking marks are not dis-

[Tracking Display] is turned off.

Check [Tracking Display] settings and make

played.

 

sure [Always] or [This Trip] is selected.

 

 

(Page 83)

 

 

 

The daylight display is used

[Daytime] is set to [Day/Night Dis-

Check [Day/Night Display] setting and make

even when the vehicle lights are

play].

sure [Nighttime] is selected. (Page 83)

on.

 

 

The orange/white lead is not con-

Check the connection.

 

 

nected.

 

 

 

 

The system will not switch on or

Installation or connection has been

Check with your dealer.

will not operate.

carried out incorrectly.

 

 

 

 

The display is very dim.

The vehicle’s light is turned ON, and

Read about [Day/Night Display] setting and,

 

[Nighttime] is selected on [Day/

if desired, select [Daytime]. (Page 83)

 

Night Display].

 

 

 

 

 

The vehicle cabin temperature is ex-

A Liquid Crystal Display (LCD) is used, and

 

tremely low.

such displays tend to darken when cold. Wait

 

 

for the vehicle to warm up.

 

 

 

 

Picture quality adjustment of the

Refer to “Page 142” to adjust the picture qual-

 

display is not correct.

ity.

 

 

 

No sounds are heard.

The volume level is low.

Adjust the volume level.

The volume level will not rise.

 

 

The attenuator or mute is on.

Turn the attenuator or mute off.

 

 

 

 

 

The speaker lead is disconnected.

Check the connection.

 

 

 

Adjusting the volume of naviga-

You cannot adjust them with VO-

Turn the volume up or down according to [Vo-

tion guidance and beeps is not

LUME knob.

lume] in [Settings] menu. (Page 80)

possible.

 

 

 

 

 

Appendix

En 145

Page 145
Image 145
Pioneer AVIC-N5 operation manual Appendix