Adjusting loudness, Using subwoofer output

	Chapter
Customizing the AV Source Setting	09

Setting a stage that fits your image

pThe [Living Room] setting that emphasizes midrange sound hardly has any effect near the maximum volume level.

pWhen you set staging other than [Off], the high pass filter (HPF) setting turns [Off].

=For details, refer to Using the high pass filter on the next page.

You can select a listener position that you want to make as the center of sound effects.

1Touch [Staging] in Sound menu.

2Touch [Position].

3Touch the desired position.

Loudness compensates for deficiencies in the low- and high-sound ranges at low volume.

1Touch [Loudness] in Sound menu.

2Touch [On] to turn loudness on. To turn loudness off, touch [Off].

3Touch cor dto select a desired level. Each time you touch cor dselects level in the following order:

Low — Mid — High

This navigation system is equipped with a sub- woofer output which can be turned on or off.

pWhen the subwoofer output is on, you can adjust the cut-off frequency, the output level and the phase of the subwoofer.

1 Touch [Sub Woofer] in Sound menu. When [Preout] (the subwoofer controller set- ting in Initial menu) is [Sub. W], you can se- lect [Sub Woofer].

= Refer to Setting the rear output and subwoo-

	fer controller on page 137.
	2 Touch [On] to turn subwoofer output
	on.
	To turn subwoofer output off, touch [Off].
	3 Touch [Reverse] or [Normal] to select
	the phase of subwoofer output.
	4 Touch [+] or [-] to adjust the output
	level of the subwoofer.
	+6 to -6 is displayed as the level is increased
	or decreased.	Customizing
	5 Touch cor dto select cut-off fre-	Customizing
	5 Touch cor dto select cut-off fre-
	quency.
	Each time you touch cor dselects cut-off fre-
	quencies in the following order:
	50 — 80 — 125 (Hz)	the
	Only frequencies lower than those in the se-	the
	Only frequencies lower than those in the se-
	lected range are output from the subwoofer.	AV
		AV
	Using non fading output	Source
	Using non fading output
	When the non fading output setting is on, the
	audio signal does not pass through navigation	Setting
	system’s low pass filter (for the subwoofer),	Setting
	system’s low pass filter (for the subwoofer),
	but is output through the RCA output.

1Touch [Non Fading] in Sound menu. Only when [Preout] (the subwoofer controller setting in Initial menu) is [Full], you can select [Non Fading].

=Refer to Setting the rear output and subwoo- fer controller on page 137.

2Touch [On] to turn non fading output

on.

To turn non fading output off, touch [Off].

3Touch [+] or [-] to adjust the output level of the non fading.

+6 to -6 is displayed as the level is increased or decreased.

En 133