Pioneer AVIC-N5 Appendix Messages and how to react to them, Message When What to do See

Appendix

Appendix

Messages and how to react to them

The following messages may be displayed by your navigation system.

pThere are occasions when you may see error messages other than those shown here. In such a case, follow the in- structions given on the display.

Message	When	What to do (See)
Please insert the appropriate	If you try to use a disc which is in-	Insert a suitable disc.
disc.	compatible with this system.
ATTENTION This is not the ap-
	If you insert a disc upside down.	Insert the disc with the label upward.
propriate disc. Please insert
	If the disc is dirty.	Clean the disc.
the appropriate disc.
	If the disc is cracked or otherwise	Insert a normal, round disc.
	damaged.

Irregular speed pulse signal is detected. Please power off the system and check the in- stallation. After you have checked, please re-boot the system and press "OK".

If the Navigation system does not re- Consult your Pioneer dealer. ceive the vehicle speed pulse.

Speed pulse wire is not con- nected. System will start to learn without speed pulse.

Please keep in mind that accu- racy is not fully ensured with- out speed pulse.

The speed signal input (pink lead wire) of the power cable is not con- nected.

To operate with 3D hybrid mode, connect the speed signal input (pink lead wire) of the power cable correctly.

Although it can be operated with Simple hy- brid mode without connecting the speed sig- nal input, the precision of the positioning will be less accurate.

Appendix

Vibration is detected. Please	The navigation unit is installed in a	Re-install the navigation unit in a place where
power off the system and	place where it may be affected by a	the unit will not be affected by vibration.
check the installation. After	large vibration.
you have checked, please re-
boot the system and press
"OK ".
Direction of G sensor is not	Direction of G sensor is set incor-	See the “Installation Manual” and set the di-
correct. Please power off the	rectly.	rection of the navigation unit correctly.
system and check the installa-
tion. After you have checked,
please re-boot the system and
press "OK".
Gyro Sensor is not working	Abnormal output is detected from	Note down the error code shown on the
properly. Please consult your	the Gyrosensor.	screen. Turn off the power, and then contact
dealer or Pioneer service cen-		your nearest Pioneer service facility.
ter.
This function is not available	The screen cannot be displayed with	If the sensor learning status reaches the Sen-
now.	Vehicle Dynamics Display. Because	sor Initializing status, the system is ready to
	the sensor has not been taught so	be used.
	the sensor information cannot be
	acquired.

En 149