Appendix
Appendix
| If the mounting angle of the naviga- The system initializes the sensor in order to | |
System detected that the ver- | tion unit has been changed. | operate it with the maximum performance |
tical angle of the installation |
| and automatically starts |
has been changed. Learning |
|
|
status for Gyro Sensor has |
|
|
been initialized. |
|
|
|
|
|
System detected that the ver- | The navigation system is installed | Confirm the installation angle. (The naviga- |
tical angle of the installation | with an extreme angle exceeding | tion system must be installed within the al- |
exceeds the permission level. | the limitation of the installation | lowed installation angle. For details refer to |
Please install the navigation | angle. | Installation Manual.) |
unit correctly. |
|
|
No data available at this time. If no data is available that can be used with the XM tuner.
Wait for a while and try the operation again.
No XM signal. Please wait.
While waiting for a response from | Wait for a while and try the operation again. |
the XM tuner. |
|
You are in an area that cannot re- | Move into an area that can receive XM tuner |
ceive XM tuner reception. | reception. |
|
|
Your current location provides very | Change your location. |
poor reception. |
|
XM updating. Please wait. | Service subscription is either XM |
| audio only or XM NavTraffic stand |
| alone. |
Since the
| Radio is being updated with the lat- | Wait until the encryption code is fully up- |
| est encryption code. | dated. |
|
|
|
Updating | The selected channel is not in- | Select another channel. |
| cluded in your subscription. |
|
|
|
|
| Radio is being updated with the lat- | Wait until the encryption code is fully up- |
| est encryption code. | dated. |
|
|
|
Route calculation was not | Route calculation has failed be- | • Change the destination. |
possible. | cause of a malfunction of map data, | • Clean the disc. |
| software, hardware or disc. | • Consult the Pioneer Local dealer if this mes- |
|
| sage persists. |
|
|
|
Route calculation was not | The destination is too far. | • Set a destination closer to the starting |
possible because the destina- |
| point. |
tion is too far. |
| • Set one or more way points. |
|
|
|
Route calculation was not | The destination or way point(s) are | Set a destination or way point(s) farther from |
possible because the destina- | too close. | the starting point. |
tion is too near. |
|
|
Route calculation was not possible due to traffic regula- tions.
•The destination or way point(s) are in a Control Traffic Zone (CTR) and the route calculation is hampered.
•Your vehicle is currently in a Con- trol Traffic Zone (CTR) and the route calculation is hampered.
•Set a destination and way point(s) outside the CTR if you know where the restricted area is.
•Try a destination or way point(s) away from the currently set points to some extent.
•Drive your vehicle to an unrestricted area and reset the destination and way point(s).
