Settings
❖Change Initial Mode
Select [Standard] to use the stand- ard settings as the initial mode which is the mode of the machine immediately after the operation switch is turned on or modes are cleared or reset.
Select [Program No.10] to use the set- tings stored in Program No.10 as the initial mode.
Selecting a custom size
When selecting [Custom Size] as the scan size, follow the procedure be- low.
A Press [Custom Size] on the Scan Size Setting screen.
Specifying Vertical and
Horizontal Measurements
(Length and Width)
A Enter the original size with the number keys.
Select and enter values for [X1] and [Y1], and then press the {#} key.
B Enter the scan starting point in relation to the standard scan starting point.
Select and enter values for [X2] and [Y2], and then press the {#} key.
C Enter the scan size (area) with the number keys.
Select and enter values for [X3] and [Y3], and then press the {#} key.
9
99
